Sunday, November 18, 2007

BLOCKAGE OF THE PITOT-STATIC SYSTEM


Errors almost always indicate blockage of the pitot tube, the static port(s), or both. Blockage may be caused by moisture (including ice), dirt, or even insects. During preflight, make sure the pitot tube cover is removed. Then, check the pitot and static port openings. A blocked pitot tube affects the accuracy of only the airspeed indicator.

However, a blockage of the static system not only affects the airspeed indicator, but can also cause errors in the altimeter and vertical speed indicator.

BLOCKED PITOT SYSTEM
The pitot system can become blocked completely or only partially if the pitot tube drain hole remains open.

If the pitot tube becomes blocked and its associated drain hole remains clear, ram air no longer is able to enter the pitot system. Air already in the system will vent through the drain hole, and the remaining pressure will drop to ambient (outside) air pressure. Under these circumstances, the airspeed indicator reading decreases to zero, because the airspeed indicator senses no difference between ram and static air pressure. The airspeed indicator acts as if the airplane were stationary on the ramp. The apparent loss of airspeed is not usually instantaneous. Instead, the airspeed will drop toward zero.

If the pitot tube, drain hole, and static system all become blocked in flight, changes in airspeed will not be indicated, due to the trapped pressures. However, if the static system remains clear, the airspeed indicator acts as an altimeter. An apparent increase in the ram air pressure relative to static pressure occurs as altitude increases above the level where the pitot tube and drain hole became blocked. This pressure differential causes the airspeed indicator to show an increase in speed. A decrease in indicated airspeed occurs as the airplane descends below the altitude at which the pitot system became blocked.

The pitot tube may become blocked during flight through visible moisture. Some airplanes may be equipped with pitot heat for flight in visible moisture.

Consult the AFM or POH for specific procedures regarding the use of pitot heat.

BLOCKED STATIC SYSTEM
If the static system becomes blocked but the pitot tube remains clear, the airspeed indicator continues to operate; however, it is inaccurate. Airspeed indications are slower than the actual speed when the airplane is operated above the altitude where the static ports became blocked, because the trapped static pressure is higher than normal for that altitude. When operating at a lower altitude, a faster than actual airspeed is displayed due to the relatively low static pressure trapped in the system.

A blockage of the static system also affects the altimeter and VSI. Trapped static pressure causes the altimeter to freeze at the altitude where the blockage occurred. In the case of the VSI, a blocked static system produces a continuous zero indication.

4 comments:

  1. but, what happens if the pitot drain is blocked? Does the lack of a leak of the pitot air cause higher indicated airspeeds?

    You can read the article above many places since it is apparently lifted from an FAA publication, but none answer the question of what happens if the drain is blocked.

    ReplyDelete
  2. What's up, everything is going nicely here and ofcourse every one is sharing information, that's actually
    excellent, keep up writing.

    Here is my page - youngasiansex.org

    ReplyDelete
  3. I believe what you published was very reasonable.
    However, what about this? suppose you composed a catchier post title?
    I ain't saying your information isn't solid., but what if you added something that makes people desire more?
    I mean "BLOCKAGE OF THE PITOT-STATIC SYSTEM" is kinda plain.
    You might look at Yahoo's home page and note how they create article headlines to get viewers interested. You might add a video or a picture or two to get readers excited about what you've got to say.

    In my opinion, it would bring your website a little bit more interesting.


    Feel free to surf to my page: www.Orgiasex.com

    ReplyDelete
  4. I loved as much as you'll receive carried out right here. The sketch is tasteful, your authored material stylish. nonetheless, you command get got an nervousness over that you wish be delivering the following. unwell unquestionably come further formerly again as exactly the same nearly a lot often inside case you shield this hike.

    my blog - porno free mubis

    ReplyDelete